The effectiveness of the gadget was very well proven in the last fishing trip ... 
The only drawback was its high volume to be transported to the fishing places, so I decided to do folding ... 
very simple thing to do, just need a drill and some screws with "knobs" to tighten them by hand ... 
This is the final result ... much more convenient to carry in any bucket or backpack. 
Post to loop the loop, we can weld the screw on the inside so it does not turn so you can tighten with one hand ... We can also give a dot of solder on the tip of the screw, so that we can not drop the wing between rocks in a careless, if slacken much the same (I). 
and should make a stop, a piece of welding rod or a nail, so you can not close while in use, having to loosen it Moth to close (II). 
is just put back the gums to form the "spring" that causes the spikes are driven alone (these are from a camera of a car tire) and give a hand cold galvanizing paint. The next will be stainless steel, when the prototype and is final ...
Now try as soon as possible, as there is another "dark."
soon and good fishing! Building
0 comments:
Post a Comment